Eng-Tips

Popular pages

• Eng-Tips

  Eng-Tips engineering forums is an intelligent work forum community for engineering professionals of all disciplines.

• Colour used for hand marked updates to engineering drawings - Chemical process engineering | Eng

  What colours are typically used for checking and updating process drawings? What about other engineering disciplines, eg civil drawings? Typically...

• Will this cart tip over? - Mechanical engineering general discussion | Eng-Tips

  Hi All! I've run into a stability problem that's stumped quite a few so far. I've searched this forum and the internet,as well. The problem seems simple...

• Connecting Forced Main to Gravity Main - Waste disposal & treatment | Eng-Tips

  I am designing a sanitary system in which I am being asked to provide a 2" forced main from a duplex grinder pump and connect it into an existing 4"...

• "INDIVIDUALLY" & "SEP REQT" - Drafting Standards, GD&T & Tolerance Analysis | Eng-Tips

  I'm using the above terms in a dimensioning scheme but not sure I am doing it correctly. We use 1994 std. Can't post a pic due to proprietary rules but will...

• What do you call your first revision? - Drafting Standards, GD&T & Tolerance Analysis | Eng-Tips

  Looking for some ideas.. when you all first create a drawing, do you start with a revision (1, or A, for example)? If so, what do you call that...